Jul 21, 2022 · The truck bed covers carries a limited warranty for three (3) years from the original date of purchase, subject to the terms below. WARRANTY IS NOT TRANSFERABLE The warranty is to the initial consumer purchasing the truck bed cover and it is not transferrable to a subsequent end user.

Driver Side of Housing Bed’s Bulkhead Driver Side Bed Rail Serial Number The serial number is 10 digits and starts with

Roll-N-Lock Tonneau Covers & Accessories | RealTruck

The truck bed covers carries a limited warranty for three (3) years from the original date of purchase, subject to the terms below. WARRANTY IS NOT TRANSFERABLE The warranty is to the initial consumer purchasing the truck bed cover …

The truck bed covers carries a limited warranty for three (3) years from the original date of purchase, subject to the terms below. WARRANTY IS NOT TRANSFERABLE The warranty is to the initial consumer purchasing the truck bed cover …

ROLL•N•LOCK CORPORATION 915 South Dixie Highway E • Pompano Beach, FL 33060 Ph. (954) 785-7655 • www.rollnlock.com. 800-952-7655 STOP! ... A. Move to the front of the bed, lift up slightly on the housing and shift each side back toward the tailgate (Photo 15)so that the track end-caps contact the inside

The truck bed covers carries a limited warranty for three (3) years from the original date of purchase, subject to the terms below. WARRANTY IS NOT TRANSFERABLE The warranty is to the initial consumer purchasing the truck bed cover …

Any damaged or missing parts? Parts will be shipped to you directly. Call 1-800-952-7655 Mon-Fri 8am - 5pm EST or email [email protected] INSTALLATION SHEET

(800) 952-7655 † www.rollnlock.com page 6 STEP 5: INSTALL THE TAILGATE EXTRUSION A. Lower the tailgate and, using a tape measure, locate and mark the center of the tailgate (Photo 15). B. Using a tape measure, locate and mark the center of the Tailgate Extrusion (Photo 15). C.

7 Remove lid from housing (A) by pushing toward cab (1) 8 and up (2) on driver and passenger side. Lid 1 2 10 Assemble the track angle (E) to the thread tang (F) using a 1/4-20 x1 1/4” bolt (G), flat washer (H). Insert