We are trying to program CDCE925PWR clock chip using CDCEL9XXPROGEVM but when we connect the programmer it gives an error in device manager "Windows cannot verify the ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

Need to drive analog PAL video over 5 meters coaxial cable, therefore it looks like capacitive AC-coupling is required. The question is if the OPA692 can drive the 75R coax load via large serial ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

To troubleshoot, I tried loading it from U-Boot. When using signed remote core firmware, the authentication verification passed successfully. However, when using ...

I set up the simulation for bidirectional current measurement as per datasheet, figure 7-6. However, the simulation does not work. It works fine, however, when only connecting one INA301. I used the ...

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...